vm/min_free_kbytes - Why Keep Minimum Reserved Memory?
linux, memory-management, operating-system
Solution
(link is dead, looks like it's now here)
That text is referring to atomic allocations, which are requests for memory that must be satisfied without giving up control (i.e. the current thread can not be suspended). This happens most often in interrupt routines, but it applies to all cases where memory is needed while holding an essential lock. These allocations must be immediate, as you can't afford to wait for the swapper to free up memory.
See Linux-MM for a more thorough explanation, but here is the memory allocation process in short:
- _alloc_pages first iterates over each memory zone looking for the first one that contains eligible free pages
- _alloc_pages then wakes up the kswapd task [..to..] tap into the reserve memory pools maintained for each zone.
- If the memory allocation still does not succeed, _alloc pages will either give up [..] In this process _alloc_pages executes a cond_resched() which may cause a sleep, which is why this branch is forbidden to allocations with GFP_ATOMIC.
min_free_kbytes is unlikely to help much with the described "ls -l takes 10-15 seconds to execute"; that is likely caused by general memory pressure and swapping rather than zone exhaustion. The min_free_kbytes setting only needs to allow enough free pages to handle immediate requests. As soon as normal operation is resumed, the swapper process can be run to rebalance the memory zones. The only time I've had to increase min_free_kbytes is after enabling jumbo frames on a network card that didn't support dma scattering.
To expand on your second question a bit, you will have better results tuning vm.swappiness and the dirty ratios mentioned in the linked article. However, be aware that optimizing for "ls -l" performance may cause other processes to become slower. Never optimize for a non-primary usecase.
Problem
According to this article: /proc/sys/vm/min_free_kbytes: This controls the amount of memory that is kept free for use by special reserves including “atomic” allocations (those which cannot wait for reclaim) My question is that what does it mean by "those which cannot wait for reclaim"? In other words, I would like to understand why there's a need to tell the system to always keep a certain minimum amount of memory free and under what circumstances will this memory be used? [It must be used by something; don't see the need otherwise] My second question: does setting this memory to something higher than 4MB (on my system) leads to better performance? We have a server which occasionally exhibit very poor shell performance (e.g. ls -l takes 10-15 seconds to execute) when certain processes get going and if setting this number to something higher will lead to better shell performance?