Which is the best approach to send large UDP packets in sequence
android, java, networking, sockets, udp
Solution
It's exactly the problem you described. Each datagram you broadcast is split into 44 packets. If any one of those is lost, the datagram is lost. As soon as you have enough traffic to cause, say, 1% packet loss, you have 35% datagram loss. 2% packet loss equals 60% datagram loss.
You need to keep your broadcast datagrams small enough not to fragment. If you have a stream of 65,507 byte chunks such that you cannot change the fact that you must have the whole chunk for the data to be useful, then naive UDP broadcast was bad choice.
I'd have to know a lot more about the specifics of your application to make a sensible recommendation. But if you have a chunk of data around 64KB such that you need the whole chunk for the data to be useful, and you can't change that, then you should be using an approach that divides that data into pieces with some redundancy such that some pieces can be lost. With erasure coding, you can divide 65,507 bytes of data into 46 chunks, each 1,490 bytes, such that the original data can be reconstructed from any 44 chunks. This would tolerate moderate datagram loss with only about a 4% increase in data size.
Problem
I have an android application that needs to send data through the protocol UDP every 100 milliseconds. Each UDP packet has 15000 bytes average. packets are sent in broadcast Every 100 milliseconds lines below are run through a loop. ``` DatagramPacket sendPacket = new DatagramPacket(sendData, sendData.length, broadcast, 9876); clientSocket.send(sendPacket); ``` Application starts working fine, but after about 1 minute frequency of received packets decreases until the packets do not arrive over the destination. The theoretical limit (on Windows) for the maximum size of a UDP packet is 65507 bytes I know the media MTU of a network is 1500 bytes and when I send a packet bigger it is broken into several fragments and if a fragment does not reach the destination the whole package is lost. I do not understand why at first 1 minute the packets are sent correctly and after a while the packets do not arrive more. So I wonder what would be the best approach to solve this problem?