return from a JMP in assembly x86?

assembly, x86

Solution

FOO needs to be called as a subroutine. To do that, invert the logic of your jump, and use the CALL instruction to call FOO. Put a RET instruction at the end of the FOO routine.

TESTIT PROC
    CMP AX,1
    JLE  BAR
    CALL FOO
BAR:
    RET
TESTIT ENDP

FOO:
    ;do something
    RET
END FOO

MAIN:
    CALL TESTIT
    .EXIT
END MAIN

END

Problem

I am calling a PROC to test two values in assembly x86 16bits and then jump if the value is bigger than zero, so I am doing something like this: ``` TESTIT PROC CMP AX,1 JG FOO RET TESTIT ENDP FOO: ;do something END FOO MAIN: CALL TESTIT .EXIT END MAIN END ``` My questions is simple, how do I return back from FOO to the point in MAIN that called TESTIT. I do not want to perform a JMP from FOO to MAIN, as that will call TESTIT again. When I try to put RET at the end of FOO, the command window gets stuck with a blinking cursor. Note: I know this can be achieved using the pseudo op `.IF ... .ENDIF` instead of JG but I want to try and achieve the same result without the pseudo op, which does some magic in the background I do not know how to achieve manually.

Original source

Related problems