tell cmake to be quiet

build, cmake

Solution

There's no variable that I know of. However, you can add the following hack to the start of your top-level CMakeLists.txt (before the `project` call) to control the output somewhat:

function(message)
  list(GET ARGV 0 MessageType)
  if(MessageType STREQUAL FATAL_ERROR OR
     MessageType STREQUAL SEND_ERROR OR
     MessageType STREQUAL WARNING OR
     MessageType STREQUAL AUTHOR_WARNING)
    list(REMOVE_AT ARGV 0)
    _message(${MessageType} "${ARGV}")
  endif()
endfunction()

This overrides CMake's built-in `message` command and suppresses all `STATUS` and untyped messages, leaving the more important types to output correctly.

The output of e.g. a `WARNING` message will change from

CMake Warning at CMakeLists.txt:14 (message):
  This is a dummy warning message.

to

CMake Warning at CMakeLists.txt:8 (_message):
  This is a dummy warning message.
Call Stack (most recent call first):
  CMakeLists.txt:14 (message)

Note that the actual line where the warning message was generated is listed in the call stack rather than being the first line of the output message.

Finally, this has no effect on the summary output which indicates success or failure of the configure attempt.

Problem

Is there a variable I can use in cmake to make it act like it was passed the -q option? It would be nice because I have a very modular build that gets messy with cmakes output. I am using it in a c++ project.

Original source